Always have a competent.
Walk in freezer installation guide.
Once panel is inserted correctly install w2 wall panel with w1 panel male edge will be inserted into female edge of w2 panel.
The installer must determine the best and safest way to get the panels to the installation site without damage or bodily injury.
Used for holding meats seafood and stuff that needs the same temperature.
The first step is to install the base channel which is attached directly to the floor with concrete anchors.
High temperature walk in cooler.
These steps are necessary to keep your walk in level square.
Medium temperature walk in freezer.
Screed identification and installation there are many styles of screeds used in floorless walk in coolers and freezers.
Walk in coolers can be setup indoors or outside.
On floored units place male bottom of wall panel in female groove of floor panel.
On floorless walk ins work panels into pre installed screeding.
First choice to make is whether you need a walk in refrigerator.
If screed was ordered with your cooler this should be laid out first.
For outdoor installation the unit.
Do not set a cooler thermostat below the walk ins design temperature or product freezing or excessive evaporator coil icing may result.
Walk ins installed near existing building walls must be positioned with a minimum 2 clearance to allow for air circulation and prevent possible condensation on the exterior surface of the panels.
A minimum of 2 clearance above the walk in is recommended to install the walk in.
Walk in cooler installation steps.
The types of screeds furnished with your unit will be identified on the unit assembly drawing.
Make sure the floor arrow on the wall panel is pointing down.
Used for holding fruits vegetables eggs medicine and wood.
2 walk in cooler freezer application.
Locate the screed floor sealer diagram which was packed in the hardware box and using it as a guide draw an outline of the outside dimensions of the installed screed directly onto the building floor where the walk in will be situated.
When placing walk in adjacent to building wall s allow 2 minimum clearance on all sides to allow for circulation and to prevent possible condensation on the exterior surface of the walk in.
The walk in coolers are walk in freezers are used in a variety of temperature ranges.
General information section 2.
Check overhead for anything that could cause a safety hazard electrical wires utility lines air ducting or any other obstructions.
The floor area that the walk in is to be installed on must be clear of all moisture dirt and debris.
Walk in cooler walk in freezer buying guide walk in refrigerator walk in freezer or combo unit.
Walk in installation operation maintenance warranty manual job name serial number.
