Using the handle lift the tank off the machine.
Vax carpet washer not dispensing water.
Our instructional video shows you how to use the vax rapid power revive carpet cleaner.
Our vax v 024 carpet washer now refuses to dispense water when the trigger is pulled.
This is a fairly lengthy and detailed look at the replacement process of the pump responsible for the dispensing of the detergent in a vax carpet cleaner.
To replace the nozzle line up the tabs on the nozzle with the tabs underneath the front of the carpet washer.
Rinse the filter under the tap to remove any dirt or debris.
I also show you the internal hose with instructi.
Ying tong iddle i po.
Pull the dirty water tank handle forward and lift the filter to remove.
Does anyone have any ideas about how to fix it peter.
There are a few other alternatives to try.
In this video i show you how to remove and clean both sets of brushes on a vax dual power pro carpet washer.
If this does not solve it the answer is most likely that the pipes and valves inside the machine are blocked by congealed shampoo.
It was blowing rather than sucking.
To cure this put a kettleful of hot water into the water tank and run the machine for a few minutes pressing the trigger on and off to give bursts of pressure to help shift the blockage.
Rinse the tank through with warm water and tip out.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Getting competent advice from the vax chat on troubleshooter was a waste of time.
I have dismantled it and found nothing obviously wrong.
Lift the nozzle release clip and pull the nozzle forward separating the tabs on the nozzle and carpet washer.
Remove both tanks and tilt the carpet washer back.
Twist to remove the dirty water tank cap.
